TWF Racing - Forums

Collapse
No announcement yet.

TWF Racing - Forums

Collapse
This is a sticky topic.
X
X
 
  • Filter
  • Time
  • Show
Clear All
new posts

  • SV Gen1 Race Harness Diagram


  • #2
    Re: SV Gen1 Race Harness Diagram

    What type of Diode is used in the harness. The previous owner just used a jumper where there is a diode shown in the schematic.

    Comment


    • #3
      Re: SV Gen1 Race Harness Diagram

      Stock one.

      Comment


      • #4
        Re: SV Gen1 Race Harness Diagram

        Ok, got everything working. One other question, what do you do with the wires going to the rear carb? Or is there something special I have to do to the carb?

        Comment


        • #5
          Re: SV Gen1 Race Harness Diagram

          TPS wires? Lock tps in wide open position and plug in to harness.

          Comment


          • #6
            Re: SV Gen1 Race Harness Diagram

            So, don't cut it from the CDI box. Guess I am soldering wires back together.

            Comment


            • #7
              Re: SV Gen1 Race Harness Diagram

              No, don't cut. I usually shorten wires and put tps near cdi.

              Comment


              • #8
                Re: SV Gen1 Race Harness Diagram

                Is it ok if I just keep it plugged in or is it better just to put it at WOT and keep it unplugged?

                Comment


                • #9
                  Re: SV Gen1 Race Harness Diagram

                  Are you using stock carbs? If yes just keep it plugged and in working order. If you using flatslides plug it in harness and lock in wot position.

                  Comment


                  • #10
                    Re: SV Gen1 Race Harness Diagram

                    Yes stock carbs. I just picked up a pair of flatslides a couple days ago. Going to wait till after this coming race weekend to put those on though. I didn't like the idea of rushing to get them on and working properly with only a short prep time.

                    Thanks for all the help!

                    Comment


                    • #11
                      Re: SV Gen1 Race Harness Diagram

                      Wire it with tps in place for now. Than when you put flats on just remove tps from carbs and lock it wide open.

                      Comment


                      • #12
                        Re: SV Gen1 Race Harness Diagram

                        Hello All, I am building a race harness for an endurance bike and would like to use the neutral switch to power a green light on my fabricated panel. Question.... what purpose do the green/black and red yellow wires going to the ECU do?
                        When checking the switch itself I there was continuity in the following positions.

                        Neutral = black/white + blue
                        2nd Gear = black / white + red / black
                        3rd Gear = black/white + green

                        So, if all I want is to illuminate the neutral light... Do I need to do anything with (other than cut and cap) the red/black and green wires?.

                        Thank you to the SV a geniuses out there!

                        John

                        Comment


                        • #13
                          Re: SV Gen1 Race Harness Diagram

                          You don't need other wires, just the ones for neutral.

                          Comment


                          • #14
                            Re: SV Gen1 Race Harness Diagram

                            Thanks for the quick answer!

                            Comment


                            • #15
                              Re: SV Gen1 Race Harness Diagram

                              Just for grins.... What purpose do the green and red/blacks serve in a stock installation? What type of info do they send to the ECU? Or what does the ECU need that they provide?

                              Comment

                              Working...
                              X